Constructing a New Driveshaft
Form 1
Fill out the form below and click Send
or click here for a form you can print and fax to us.
This form applies to cars, 4 x4’s, light duty trucks and high performance vehicles. One of the diagrams below should apply for your vehicle. Measurements must be taken with weight on suspension to determine the proper working length.
Transmission Type
Measurement ADifferential Type
Transmission Type
Measurement BDifferential Type
Transmission Type
Measurement CDifferential Type
Transmission Type
Measurement DDifferential Type
Transmission Type
Measurement EDifferential Type
Enter measurements here
Material type
A—Measure from tip of splined transmission output shaft to flat of flange rear differential.
B—Measure from tip of splined transmission output shaft to outside tip of differential yoke.
C—Measure outside tip of transmission yoke to outside tip of differential yoke.
D—Measure flat of transmission flange to flat of flange rear differential.
E—Measure outside tip of transmission yoke to flat of flange rear differential.
Yes No
If the trans is a TH400 is the spline drilled and threaded at the end of the output shaft?
Customer Information
First Name Phone
Last Name Fax
Questions? Date
Email
Your privacy is of utmost importance to us, and we will not use your Email address or phone number for any purpose other than our business needs. We do not sell, trade, lease or otherwise divulge any identifying information from visitors to our web site.
Midwest Driveshaft, Inc.
3712 Illinois Ave.
St. Charles, IL 60174
630-513-9292 phone
630-513-9387 fax

email usemail us

© 2006 Midwest Driveshaft,Inc. • All Rights Reserved
3712 Illinois Ave.
St. Charles, IL 60174
630-513-9292 phone
630-513-9387 fax